LGMG AS1932, Operation And Safety Manual

Page: 30 / 62

LGMG North America Inc.
Operation and Safety Manual
22
6.11 Driving and Braking
Function Test
1) Press the enable switch on the control
handle.
2) Slowly push the control handle as per the
direction of the forward arrows on the control
panel until the machine is moving and return
the handle to the center position. Result: The
machine shall move forward and then stop.
3) Slowly move the control handle as per the
direction of the backward arrows on the
control panel until the machine is moving and
return the handle to the center position.
Result: The machine shall move backward
and then stop.
△
! Notice
The brake must be able to stop the
machine on any grade.
6.12 Driving Function Test
1) Press the lift function button; the indicator
lamp will light up. Press and hold the enable
switch to lift the platform to the height called
out in the following table. Result: The pothole
guards will be deployed.
Table 5 - Pothole Deployment Height When Driving
Model Height
AS1932
4.3ft (1.3m)
AS3246
6.9ft (2.1m)
AS2646
2) Press the drive function selector button. The
indicator light will light up.
3) Press the enable switch on the control handle
and slowly move the control handle fully
forward. Result: The drive speed of the
platform will not be greater than 0.5mph
(0.8km/h) when the platform is elevated. If
the elevated driving speed of the platform
exceeds these limits, immediately tag out the
controls and stop operation until repairs are
made.
6.13 Operation of Tilt Sensor
Test
△
! Notice
This test is performed with the platform
controller from the ground. Do not stand
in the platform.
1) Completely lower the platform.
2) Drive two wheels on the same side of the
machine up on a 1.37×7.9in (3.5×20cm)
block.