10
3. Short Circuit or Overload
Overload Protection
A built-in overload protection protects the power pack in the event of an overload or
a short circuit. The locomotives will come to a stop, solenoid accessories cannot be
controlled, and all lamps/lights connected to the layout will go out.
The following procedure is recommended:
1. Unplug the power pack from the wall outlet.
2. Look on the layout for the cause of the short circuit and correct it.
3. After about 1 minute the overload protection
will go back to regular operation.
After this period of time has passed, the power pack can be used again.
If the power pack shuts off again without a short circuit being found, then the power
pack is overloaded. In this situation the number of users on the layout (locomotives,
solenoid accessories, and lamps/lights) must be reduced.
4. Trouble Running the Train
• If the locomotive does not run, check to make sure that the connections (see
setup) are correct or that the wire insulation was pushed into the terminal or that
the switched mode power pack is plugged into the power outlet.
• If the locomotive becomes damaged, do not use the locomotive anymore. If car
becomes damaged, remove this car from the train and do not use it anymore.
5. Cleaning and Maintenance
• Check to see if hair or dirt gets on the axles on the train and remove this hair or dirt
from the axles with the help of a pair or tweezers so that the train runs correctly.
• The train can be wiped with a dry, lint-free cloth.
6. Disposing
Products marked with a trash container with a line through it may not be
disposed of at the end of their useful life in the normal household trash.
They must be taken to a collection point for the recycling of electrical
and electronic devices. There is a symbol on the product, the operating
instructions, or the packaging to this effect. The materials in these items
can be used again according to this marking. By reusing old devices,
materially recycling, or recycling in some other form of old devices such
as these you make an important contribution to the protection of our environment.
Please ask your city, town, community, or county authorities for the location of the
appropriate disposal site.
7. Warranty
The warranty card included with this product specifies the warranty conditions.
8. Locomotive
8.1 Safety Notes
• This model may only be used with the operating system designed for it.
• Use only switched mode power supply units and transformers that are designed
for your local power system.
• This locomotive must never be supplied with power from more than one power pack.
• Pay close attention to the safety notes in the instructions for your operating system.
• Not for children under the age of 15.
•
WARNING!
Sharp edges and points required for operation.
8.2 Important Notes
• The operating instructions are a component part of the product and must therefore
be kept in a safe place as well as included with the product, if the latter is given to
someone else.
• Please see your authorized LGB dealer for repairs or spare parts.
• The warranty card included with this product specifies the warranty conditions.
• Disposing: www.maerklin.com/en/imprint.html
8.3 Functions
• This model is designed for operation on LGB two-rail DC systems with conventio-
nal LGB DC train controllers or power packs (DC, 0 – 24 volts).
General Note to Avoid Electromagnetic Interference:
A permanent, flawless wheel-rail contact is required in order to guarantee operation
for which a model is designed. Do not make any changes to current-conducting parts.
