LG WF-T8500TP, Owner'S Manual

Page: 21 / 54

User Maintenance Instructions
U
ser Maintenance Instructions
21
Check it if water leaks after reassembling. (The gasket is in the cap)
To Clean the Pump Casing
Caution
To Clean the Filter in the Inlet Valve
Close the tap before turning off the
power. Select both hot/cold and then
press the [
START/PAUSE ] button to
remove water remaining in the water
hose completely.
In case the water supply is impure, check substances like stone or sand in the filter. If the filter is clogged with dirt, water
cannot flow into the washer. Clean the filter regulary. (The figure of power cord and water tap may vary by country.)
After disconnecting the water
supply hose, remove the filter
from the inlet valve by hand
or with tools. Then remove
dirt with a brush, etc.
Turn off the power and
disconnect the power
cord.
Replace the filter into the water
inlet after cleaning it.
1 2
3 4
Before cleaning the filter, water remaining in the water supply hose should be emptied.
Caution
To Clean the Lint Filter
Turn the net inside out
to remove dirt and
rinse it with water. Pull out the lint filter from
the tub in the direction
shown below. Replace the filter to the
original location. Push
the lip of the filter until
a pop sound is heard. 1 2 3
Note
• If the lint filter is worn out or damaged, contact a LG Service Center for new one.
• The amount of collected lint depends on the load size and type.
Clean the lint filters when cleaning is needed.
Place a towel on the
floor under the drain
pump cap. Excess
water may flow out. Remove any foreign
objects and fluff inside
pump casing and from the
filter.
Replace the cap. Insert the filter along
the guide ribs inside the pump casing.
Filter must face the guide ribs inside
pump casing and securely turn the cap
clockwise.
1 2 3 4
Turn the cap
counter-
clockwise and
pull it out.
Filter
Cap
Guide rib
Filter