LG W7AWB, Installation Manual

Page: 7 / 16

7
ENGLISH
If there is space between the inner wall and the board
Air gap
Front
Back
Dr
ayw
all / Marble
Brick
•
When fastening the screws, use M5 screws at more than two points (a depth of 40 mm is recommended).(It is
recommended that you fasten the screws at an equal distance from the left and right sides based on the center
hole. If this is not possible, apply additional reinforcements as near as possible.)
•
When installing the product on wall material not designated, install the product so that each location can
withstand the pull out load of 70 kgf (686 N) and shear load of 100 kgf (980 N) or above.
•
Use the Ø 8 mm drill bit for concrete and hammer (Impact) drill.
1 2
3
Wall mounting anchor
4
5
Wall mounting screw
1
Use a drill bit Ø 8 mm to drill a hole for the anchor location within a depth of 80 mm to 100 mm.
2
Clean the drilled hole.
3
Insert the sealed wall mounting anchor to the hole. (When inserting the anchor, use a hammer.)
4
Set the wall mount on the wall by aligning to the location of the hole. And, set the angle adjusting part
to face upward.
5
Align the wall mounting screw to the hole and tighten it. Then, fasten the screws at torque of 45 kgf/cm
to 60 kgf/cm.