LG W3NQ08UNNP1, Owner'S Manual

Page: 14 / 49

13 OPERATION
EN
Clean Filter
The Clean Filter LED lights up to notify you
that the filter needs to be cleaned. After
cleaning the filter, press
Temp and
together on the control panel to turn off the
Clean Filter light.
NOTE
• The filter reset must be done using the
control panel, not the remote control.
• This feature is a reminder to clean the air
filter for more efficient operation. The LED
light turns on after 250 hours of operation.
Fan Speed
Press to set the fan speed to Low (F1),
Medium (F2), or High (F3).
Temperature Control
The thermostat monitors room temperature to
maintain the desired temperature. The
thermostat can be set between 16 °C–30 °C
(60 °F–86 °F). Press
or arrows to
increase or decrease temperature setting.
Energy Saver
In this mode the compressor and fan turn off
when the set temperature is achieved.
Approximately every 3 minutes the fan turns
on to allow the unit sensor to accurately
determine if more cooling is needed.
NOTE
• This function is available with Cooling Mode.
Clear
Cancel Sleep and Timer settings. Also set the
Diagnosis if held for 5 seconds.
NOTE
• Auto Restart : If the air conditioner turns off due
to a power outage, it will restart automatically
once the power is restored, with the same
settings as were set before the unit turned off.
• Energy Saver : The unit defaults to the Energy
Saver mode each time the unit is switched on
except in Fan mode or when power is restored
after an electrical power outage.
• The remote control will not function properly if the
AC infrared sensor is exposed to direct light or if
there are obstacles between the remote controller
and the air conditioner.
Using the Light Off Function
You can set the brightness of the control panel.
• Press Mode button on the remote control for
3 seconds, or
• Press Mode and Sleep button together on the
control panel .
NOTE
• Turn on/off the control panel.
Using the Auto Clean Function
In the Cooling and Dry Mode, Moisture is
generated inside the indoor unit. This function
removes such moisture.
• Press Energy Saver button on the remote
control for 3 seconds.
• is displayed on the remote control.
NOTE
• If you turn off the unit, the fan continues to run
for 10 minutes and cleans the inside of the
indoor unit.