16
Replacing Dust Bag
Check the bag from time to time. When excessive
dirt accumulates, your cleaner may not operate
effectively.
If the cleaner does not seem to have adequate
suction, check the bag.
DISCONNECT THE CLEANER FROM
THE ELECTRICAL OUTLET.
Pull the dust cover grip forward and remove the
dust cover from the cleaner. (Fig. A)
Grasp the dust bag collar and pull it out.
Attach a new dust bag onto the bag holder
holding the dust bag collar and pushing back as
shown in the figure. (Fig B)
Insert the tabs on the bottom of dust cover into
the grooves on the dust compartment. (Fig. C)
Rotate the dust cover up into the closed position
and press it until the hook snaps into place.
Replacing Clean Filter
The clean filter is located inside the dust
compartment. When installing or changing the
dust bag, always check this filter. When the filter
becomes dirty, clean it or install a new one.
To remove this filter, open the dust cover and pull
the filter out from the bottom of dust compartment.
To clean the old filter, rinse it in water and dry it.
Slide this filter back into place. It should be fully
inserted into the projections of the bottom of dust
compartment. Be sure the filter is dry.
REPLACEMENT INSTRUCTIONS
WARNING
Electrical Shock or Personal Injury Hazard
Disconnect electrical supply before servicing or cleaning the unit. Failure to do so
could result in electrical shock or personal injury if the cleaner starts suddenly.
A
A
B
B
C
C
Summary of Contents for V-UP255NB
Page 20: ...19 MEMO ...
Page 21: ...20 ...
