12
Air Conditioner
Remote Controller Installation
12V SIG GND
Red
Yellow
Black
Remote Controller
Cable
Guide slot
Fixate the remote
controller cable
to the guide slot.
Use the screws
for fixate the unit
firmly on the wall.
Installation board
<Front side of
installation board>
<Rear side of
installation board>
Top
Bottom
Wall
Side
Wall
Side
Wall
Side
Wall
Side
Wall
Side
1. Connect the remote controller cable to the
wired remote controller installation board as
shown in the right picture.
2. After fixing the cable to the guide slot,
attach the wired remote controller
installation board at the desired location.
• Before fixing the remote controller cable to the
guide slot, remove any clogged part of the case
in the direction to install before the installation.
3. After locating the wired remote controller
installation board at the desired location,
screw the unit firmly. (When there is a buried
box, install the wired remote controller
board to fit the buried box.)
• Use the screws provided.
4. After fixing the top part of the remote
controller to the installation board as shown
in beside picture, press the bottom part to
assemble the controller to it’s board.
When disassembling the remote controller from
the installation board, use the driver as shown in
the right picture and insert it into the hole with the
arrow. And when you pull the driver in the front
direction, the remote controller will be separated.
12V
Red wire
SIG
Yellow wire
GND
Black wire
❊
The remote controller cable is connected as factory default.
Summary of Contents for UU21WH
Page 34: ...34 Air Conditioner Memo ...
