7
EN
•
Do not use a plug socket and wiring equipment for more than their
rated capacity.
•
When the air temperature is high and the water temperature is low,
condensation may occur and thus wet the floor.
•
Wipe off dirt or dust on the contacts of the power plug.
•
Under certain conditions hydrogen gas may be produced in a water
heater that has not been used for two weeks or more. Hydrogen
gas can be explosive under these circumstances. If the HOT water
has not been used for two weeks or more, prevent the possibility
of damage or injury by turning on all Hot water taps and allowing
them to run for several minutes. Do this before using any electrical
appliance which is connected to the HOT water system. This simple
procedure will allow any built-up hydrogen gas to escape. Since the
gas is flammable, do not smoke or use an open flame or appliance
during this process.
Maintenance
•
Remove the power plug when you clean the appliance.
•
Securely plug the power plug in the socket outlet after completely
removing any moisture and dust.
•
Do not spray water inside or outside the appliance to clean it.
•
Never unplug the appliance by pulling on the power cable. Always
grip the power plug firmly and pull straight out from the socket
outlet.
•
Only qualified service personnel from LG Electronics service centre
should disassemble, repair, or modify the appliance. Contact an LG
Electronics customer information centre if you move and install the
appliance in a different location.
