LG T2108VS2M, Owner'S Manual

Page: 8 / 44

8
EN
• Do not use a plug socket and wiring equipment for more than their
rated capacity.
• When the air temperature is high and the water temperature is
low, condensation may occur and thus wet the floor.
•
Wipe off dirt or dust on the contacts of the power plug.
•
Under certain conditions hydrogen gas may be produced in a
water heater that has not been used for two weeks or more.
Hydrogen gas can be explosive under these circumstances. If the
HOT water has not been used for two weeks or more, prevent the
possibility of damage or injury by turning on all Hot water taps and
allowing them to run for several minutes. Do this before using any
electrical appliance which is connected to the HOT water system.
This simple procedure will allow any built-up hydrogen gas to
escape. Since the gas is flammable, do not smoke or use an open
flame or appliance during this process.
Maintenance
•
Remove the power plug when you clean the appliance.
•
Securely plug the power plug in the socket outlet after completely
removing any moisture and dust.
•
Do not spray water inside or outside the appliance to clean it.
• Never unplug the appliance by pulling on the power cable. Always
grip the power plug firmly and pull straight out from the socket
outlet.
•
Only qualified service personnel from LG Electronics service
centre should disassemble, repair, or modify the appliance.
Contact an LG Electronics customer information centre if you
move and install the appliance in a different location.