A) Connection to any IBM VGA PC compatible system
Figure 3 shows the signal cable connections from the monitor to the
Video Graphics Array (VGA) port typical in an IBM PC or PC compati-
ble. This also applies to any graphics video card for PC-CAD or work-
station that has a 15 pin high density (3 row) D-Sub connector.
1. Power off both the monitor and PC.
2. Connect the 15 pin VGA connector of the supplied signal cable to
the output VGA video connector on the PC and the matching input
connector on the rear of the monitor. The connectors will mate only
one way. If you cannot easily attach the cable, turn the connector
upside down and try again. When mated, tighten the thumbscrews
to secure the connection.
3. Power ON the PC, then the monitor.
4. If you see the "SELF DIAGNOSTIC" message, check the signal
cable and connectors.
5. After using the system, power OFF the monitor, then the PC.
Figure 3.
6
Power Cord
Signal Cable
D-15P
D-15P
Computer
VGA Compatible
PC System
R
G
B
H+V
V
(Rear of Monitor)
Signal Cable
