9
Installer Connections
The RJP-201M and the cables listed below are to be connected to both the TV display panel
and any entertainment resources available in the room.
CAUTION: Be sure power is turned off before attempting to connect the RJP-201M to the
TV display panel and in-room resources.
MIXED SIGNAL
OUT
NETWORK
OUT
PHONE
OUT
PHONE
OUT
NETWORK
OUT
MIXED SIGNAL
OUT
AC Power Cord
Connect to 120V 60 Hz AC
power outlet. Supplies
power to the four conve-
nience AC power outlets for
end-user. (Maximum com-
bined total current allowed
is 7 Amps.)
6-Pin RJ-11 Phone Cable
Connect to telephone line
wall jack panel.
Network Cable (8-Pin RJ-
45) w/Black Protective
Sleeve
Connect to LAN wall jack
panel.
Mixed Signal Cable
Mixed Signal Cable from Mixed
Signal Breakout Cable assembly
must connect to Mixed Signal Out
Connector.
Otherwise damage will occur.
Network Port (8-Pin RJ-45)
Connect to LAN wall jack, if available. Allows the end-user to access
the LAN (local area network) server of the institution.
Phone Port (6-Pin RJ-11)
Connect to telephone line wall jack. Allows the end-user, using a
computer modem, to connect to their ISP (Internet Service
Provider) to access the Internet through a local phone line.
AC Power Cord (Installed on RJP)
Connect to standard 120V 60Hz AC power outlet.
(Four 120 Volt 60 Hz AC power outlets are provided for
the end user.
However, 7 Amps. is the maximum combined current
allowed for the AC outlets.)
