Owner’s & Installation Manual
9
8
Weekly Wired Remote Controller
Address setup of central control
Program set
Room Temp
HI
MED
LO
Timer
On
Time
Off
01
03
05
07
09
11
13
15
17
19
21
23
ZONE
1 2 3 4
AUTO SWING
AUTO
JET
Heater
Defrost
Preheat
Humidify
Filter
Out door
Time
OPERATION
SET TEMP
FAN SPEED
SUB FUNCTION
Set no.
Operation unit
2ndF
PLASMA
Timer
Program
Hour
Cancel
Week
Holiday
Set/Clr
Min
RESET
1
You can set the address up by pressing the Program
button and the Set/Clr button about 3 seconds at the
same time.
2
The group change uses the temperature control button
to change the value possibly. The number of indoor
unit uses the temperature control button to change the
value possibly.
Ex) Group address: 2
Indoor unit number: 3
3
You can complete setting up the address by pressing
the Program button and the Set/Clr button about 3
seconds at the same time.
• Multi model: Connect the outdoor unit and P1485 of outdoor unit
• Single model: Connect P1485 of outdoor unit
• When you connect the indoor unit with central control unit, you should setup Network address which is
recognized by central control unit inside of indoor unit.
• The address of central control is consisted by group number and number of indoor unit.
• Multi model: Connect the outdoor unit and P1485 of outdoor unit
• Single model: Connect P1485 of outdoor unit
• When you connect the indoor unit with central control unit, you should setup Network address which is
recognized by central control unit inside of indoor unit.
• The address of central control is consisted by group number and number of indoor unit.
Note :
The remote controller displays 'HL' if central controller has locked the remote controller.
Address setup of central control
Remote controller connection method
Remote controller connection method
1. Check the cable is conneced with CN-REMO
(CN-VENTIL is used if remocon is connected with ventilator)
2. Connect the cables between the indoor unit and the remote controller.
Connector for the
remote controller side
Connector for the
indoor unit side
Room Temp. Sensing
Remo .
Indoor Unit
2TH(Remo+Indoor)
Low
Standard
High
Single
Group
Ceiling Height
* When installing the wired remote controller, do not install it buried within the wall.
(It can cause problems to the temperature sensor.)
Do not install the cable for longer distance than 50m. (It can cause a communication error.)
When installing the cable, check the connector between the remote controller and the connector. The
connector will not be connected well when connected backwards.
CAUTION
