5
EN
G
LI
SH
4
How to assemble the wall mount support and display
1. Set the display with the guide spacer assembled on the
wall mount bracket on the wall in arrow direction.
At this time, align the bottom assembly part and lift the
set up lightly to align the top part.
(For PSW400B / PSW400BG models, connect the
power cord first when installing the set on the wall mount.)
2. When adjusting the location, assemble the provide
safety clip as shown in the picture to prevent the product
from moving. Tighten the safety clip screw completely. If
the safety clip is not tightened as shown in the picture,
the product can fall off.
→
Pull on the bottom of the set to make sure the display
is secure.
→
The distance between the installed TV and the wall will be 17.8 mm.
(If you install the wood fixing bracket, the distance will be 23.8 mm)
Make sure to keep a certain level of distance
from the wall so that excessive force is not applied on the
cable or accessory.
→
When you push the product with excessive force,
the product can be damaged.
- For PSW600B / PSW600BG models, remove the
height adjusting screws before installing the wall
mount, and then assemble the extended bracket.
Use the removed screws to install the extended
bracket.
- Before installing the wall mount, secure the 4
bracket fixing screws on the upper left and right
sides respectively and 4 on the lower left and right
sides respectively.
(Use a hand or electric cross-head screwdriver.)
- A fastening adhesive is provided to make sure that
the bracket fixing screws are fully inserted.
- Always install the display with 2 or more people.
* PSW600B / PSW600BG models only.
Safety clip
Safety clip
screw
406mm(16inches
)
drywall
76mm(3inches)
drywall
wood stud
Power cord
* For PSW400B / PSW400BG
models, connect the power cord
to the set first.
* Insert the safety clip into the wall
mount bracket and secure them
with the fixing screw.
<When mounting to wooden studs>
a. Locate and mark the centers of
the wall studs using a stud finder.
b. After aligning the wall bracket on the wall where the center of the wood stud is
marked, mark the location of the screws and then remove the wall bracket.
c. Use a level to make sure your screw marks are level.
d. Use the 4mm drill bit for wood to drill holes with the depth of 76mm or above
where the wall mount screw location is marked on the wall.
e. Clean the drilled hole.
f. Tighten the wall mount screws for the wall bracket on the drilled hole.
→
At this time, tighten the screw so that the wall, wall bracket and the wall mount
screw are pressed against one another. (Drywall can be damaged when tightened
with excessive force, please be careful.)
→
When tightening the screw use the "+" driver (Manual or motorized) or 8mm
wrench.
