LG PREMTA200, Owners & Installation Manual

Page: 26 / 30

26 INSTALLER SETTING
Function
Product
Description Option
AIRCON VENTILATOR
Static Pressure Step O
This function allows you to set the static pressure
of the duct product by subdividing it into 11 steps.
Step 0~ Step 11
If you step settings, static pressure settings is
not used.
• Refer to the indoor unit product manual for the
static pressure values in each step.
Guard Timer O
The standby time can be set to protect the outdoor
unit during cycle transition of 2 set auto mode
operation.
Step 0 Step 1 Step 2 Step 3 Step 4
0 min 15 min 30 min 45 min 60 min
Fan Speed in
Cooling Thermal Off
O O
It is a function that sets the indoor unit fan
operation, in cooling mode, when thermal is off.
Low / Off / Setting value
Primary Heater O
When it is heating mode, the use of the heater
can be prioritized over the outdoor unit cycle to
increase efficiency.
On/off toggle
AC. Fan Oper.
Interlocked With
Vent.
O
It is a function to set the operation status of air
conditioner fan when the air conditioner is off, in
the interlock status of the ventilation product, and
when operating ventilation product.
Off
Fan off
Low
Extremely low
wind
Indoor unit Auto
Start
O O
In the event of a power outage, you can set
whether to recovery the product to its previous
operating state.
Not use
Reset to operation off state
Use
Reset to previous
operation state
occupancy duration
time
O
This function sets the minimum retention time
required for occupancy condition recognition when
using an occupancy sensor through dry contact.
0 / 10 / 30 / 60 min
CN-CC O
This function is used to set the usage of the CN_
CC port of the indoor unit. Automatic / Manual Uninstalled / Manual
installed
CN-EXT O O
This function determines the use of the CN_EXT
port of the indoor unit.
• Not use: Use simple dry contact setting
• Simple operation: control Simple operation
On/Off
• Single emergency stop: Indoor unit single
emergency stop
• Occupied / Unoccupied: Occupied /
Unoccupied
• All emergency stop: Indoor unit all emergency
stop
It can be set only when there is indoor unit
emergency stop function.
• Window contact: Window contact
It can be set only when there is window
contact function.
• Window contact lock: Window contact with
lock
It can be set only when there is window
contact lock function.
ODU Function
Master
O O
It is the function to set the outdoor unit’s function
Master / Slave.
Master / Slave.
FAN Continuous
operation
O
Fan operation of the indoor unit can be operated
longer than before to maximize cooling/heating
efficiency.
On/Off
Low noise mode
priority
O O
This function sets the object to prioritize low noise
mode.
Outdoor unit / Remote controller
Lamp Color Setting O
This function selects the LED color to display the
fine dust status of the product.
Automatic / RGB / YGG
Dust Step Color
Setting
O
You can change the color display method for each
stage of fine dust according to national standards.
Type1: Blue-Green-Orange-Red
Type2 : Green-Yellow-Orange-Red
Type3 : Green-Yellow-Orange-Red-Pink-Purple
Human Detection
Sensor
O
Set up detailed settings for using the human body
detection kit.
Humidity Sensing
Position
O
This function sets the position of humidity
detection.
Remote controller / Indoor unit
ODU Cycle Priority O
This function sets the standby mode/ priority
cooling function usage setting and cooling thermal
off time when setting the priority cooling. Not use
Standby Mode
Priority
Outdoor Temp. For
Heating Stages
O
This function sets the standard of outdoor unit
cycle and heater operation according to outdoor
temperature conditions.