7
ENG
English
ASSEMBLING AND PREPARING
y
y
Once the pin is removed, it is not necessary
to re-insert it to adjust the height.
Adjusting the stand height
1
Place the monitor mounted on the stand base
in an upright position.
Adjusting the angle
1
Place the monitor mounted on the stand base
in an upright position.
2
Remove the
tape
attached at the bottom rear
of the
stand body,
then pull out the
locking
pin
.
3
The height can be adjusted up to
110 mm
.
2
Adjust the angle of the screen. The angle of the
screen can be adjusted up to 15° forwards and
5° backwards for a comfortable viewing experi-
ence.
y
y
To avoid injury to the fingers when adjusting
the screen, do not hold the lower part of the
monitor's frame as illustrated below.
y
y
Do not put your finger be-
tween the screen and the
base (chassis) when adjust-
ing the screen's height.
y
y
Be careful not to touch or press the screen
area when adjusting the angle of the monitor.
15
- 5
Front Side
Rear Side
15
- 5
Tape
Locking Pin
Stand Body
110.0 mm
CAUTION
WARNING
WARNING
