2
ENGLISH
for washer/combo
for dryer
for dryer
for washer/combo
Lock nut
Adjustable feet
Adjustable feet
Leg Extension
IMPORTANT: Read and follow these instructions.
NOTICE
The installer must have electrical and mechanical training and acceptable knowledge in the
required work.
Safety is foremost---both your own and that of other
people. Many important safety instructions are provided
in this instruction and your appliance. Always read and
observe all safety instructions.
Remove pedestal,installation hardware, and
instructions from the shipping carton.
Position the washer/combo on top of the pedestal.
WARNING
Excessive Weight Hazard
Two or more people may be needed to install and
move the appliance and pedestal assembly.
Do not allow children to play on the drawer.
Do not step on the handle.
A firm, solid floor is even more critical to a front-loading
washer than to a top-loader. If your floor is wooden
and /or frame construction, you may need to reinforce
it. Front-loaders have substantially faster spin speed
than top-loaders, causing greater vibration. If the floor
is not solid, your washer will vibrate.
WASHER/COMBO INSTALLATION
Before installing the pedestal, remove foreign
objects on the floor clean the floor. Dust, water, oil,
detergent and so on could cause vibration due to
bad contact of legs with floor.
After the washer is leveled, tighten the lock nuts up
toward the base of the washer using the wrench. All
four lock nuts should be tightened.
Level the pedestal on the clean place by adjusting
the feet.
NOTE
If a drip pan must be used, take
extra care to follow the
instructions provided with the drip
pan and make sure the leveling
feet are adjusted for firm and even contact with the pan. Use
of drip pans and failure to properly level the machine may
result in increased vibration and noise during operation.
NOTE
Do not extend the legs no more than necessary to
level the washer. The more the legs are extended, the
more the washer will vibrate.
NOTE
Because of the weight of the washer/combo, two or
more people may be needed.
NOTE
If the washer or combo was previously installed,
unplug it, disconnect the inlet hose (s)from the faucet
(s), disconnect the drain hose, and drain all hoses.
NOTE
4 Holder
eighteen
4x20mm
Truss taptite
Drawer Divied
11/16” or 17mm
Open End Wrench
Phillips
screwdriver
Included Accessories
Tools Needed
Summary of Contents for LWP-277 Series
Page 1: ...3828ER4001V ...
