ENGLISH
11
INSTALLATION
How to Install the Unit
Window Requirements
●
This unit is designed for installation in standard
double hung windows with actual opening
widths from 27" to 39".
The top and bottom window sashes must open
16" from the bottom of the upper sash to the
inside sill.
●
The height offset between the inside sill and
outside sill must be less than 1 ¼".
27" to 39"
16" min
NOTE
●
wood, masonry, or metal.
Preparation of Cabinet
1
Remove 4 screws which fasten the cabinet
at both sides and at the back. (Keep the
screws for later use.)
1
To prevent vibration and noise, make sure
the unit is installed securely and firmly.
4
Install the unit slightly tilted so the back is
slightly lower than the front (about 1/2").
This will force condensed water to flow to
the outside.
5
Install the unit with the bottom between
30" ~60" above the floor level.
2
Install the unit where the sunlight dose not
shine directly on the unit.
3
The outside of the cabinet must extend out-
ward for at least 12" and there should be no
obstacles, such as a fence or wall, within 20"
from the back of the cabinet because it will
prevent heat radiation of the condenser.
Restriction of outside air will greatly reduce
the cooling efficiency of the air conditioner.
Fence
Awning
Heat
radiation
Cooled air
CAUTION
●
All side louvers of the cabinet must remain
exposed to the outside of the structure.
Shipping
Screws
CAUTION
●
The unit is heavy. To prevent injury, use
proper lifting techniques when pulling unit
forward from cabinet. Obtain assistance
from another person if possible.
3
Cut the window sash seals (Foam-PE)
to the proper length. Peel off the backing
and attach the adhesive-backed foam to
the underside of the window sash and the
bottom of the window frame.
Foam-PE
(Adhesive backed)
2
Slide the unit from the cabinet by gripping
the base pan handle and pulling forward
while bracing the cabinet.
Summary of Contents for LW8019ER
Page 26: ...26 MEMO Memo ...
