7
Clean Filter
The Clean Filter LED lights up to notify you
8
Energy Saver
In this mode the compressor and fan turn
off when the set temperature is achieved.
Approximately every 3 minutes the fan turns
on to allow the unit sensor to accurately
determine if more cooling is needed.
9
Timer Clear
Cancel Timer setting.
Temp
and
together on the control panel to turn off the
Clean Filter light.
NOTE
●
●
This feature is a reminder to clean the air
filter for more efficient operation. The LED
light turns on after 250 hours of operation.
5
Temperature Control
The thermostat monitors room temperature
to maintain the desired temperature. The
thermostat can be set between 60 °F–86 °F
(16 °C–30 °C). Press
or
arrows to
increase or decrease temperature setting.
NOTE
●
Auto Restart:
If the air conditioner turns off due
to a power outage, it will restart automatically
once the power is restored, with the same
settings as were set before the unit turned off.
●
Energy Saver:
The unit defaults to the Energy
Saver mode each time the unit is switched on
except in Fan mode or when power is restored
after an electrical power outage.
●
The remote control will not function properly if
the AC infrared sensor is exposed to direct light
or if there are obstacles between the remote
controller and the air conditioner.
14
OPERATION
that the filter needs to be cleaned. After
cleaning the filter, press
6
Remote Control Sensor
The filter reset must be done using the
control panel, not the remote control.
NOTE
●
This function is available with Cooling
Mode.
Wireless Remote Control
Inserting Batteries
If the display screen of the remote control begins
to fade, replace the batteries. Insert AAA (1.5 V)
batteries before using the remote control.
1
Remove the cover on the back of the
remote control.
2
With the plus and minus poles facing as
marked, insert two new AAA 1.5V batteries
NOTE
●
Two new batteries are supplied with the air
conditioner for use in the remote control.
●
Do not use a rechargeable battery. Make sure
that the battery is new.
●
In order to prevent discharge, remove the
battery from the remote control if the air
conditioner is not going to be used for an
extended period of time.
●
Keep the remote control away from extremely
hot or humid places.
●
To maintain optimal operation of the remote
control, the remote sensor should not be
exposed to direct sunlight.
