LG LV281M, Owner'S Manual

Page: 7 / 30

7
Make sure that you have
correctly installed your
VCR as described earlier
in this book.
Press POWER to turn on
your VCR.
Turn on your TV.
Insert a pre-recorded
video tape into your VCR
and press PLAY on the
remote control.
Select a TV channel
number on which you
wish to watch video’s.
Don’t worry if you don’t
have a video-tape to play
at this stage!
If you switch your VCR
on and continue stages
3 ~ 4, instead of seeing
video playback tune your
TV until you see a bright
blue screen.
Tune this channel until
the video picture is sharp
and the sound is clear.
If you have used a
SCART cable you will
not have to tune your TV,
simply select the AV
channel. The AV channel
is already pre-tuned for
optimum video playback
on your TV.
Store this channel on
your TV.
You will need to look at
the TV instruction book if
you do not know how to
do this.
T
uning in a
V
ideo
channel
On
your
TV
Your TV receives signals from the video recorder (VCR) like another TV station.
You have to select a channel number on your TV and tune it in so that you may watch video
tapes.
If you have used a SCART cable then your TV should already have a dedicated video
channel built into it, usually called AV.
The output frequency of
this video recorder (VCR)
is set at UHF channel 36.
If channel 36 is already
used by another TV
station, or if the picture is
distorted, you can
change the transmitter
channel of your VCR.
Stages 5 ~ 8 will show
you how to change the
output frequency of your
VCR.
TV/VCR TV/VCR AV AV CM SKIP CM SKIP
ez POWER OFF ez POWER OFF
G-CODE C.LOCK
ez REPEAT
EJECT EJECT POWER POWER
TV/VCR AV CM SKIP
ez POWER OFF
C.LOCK
PROG.
ez REPEAT
EJECT
POWER
CLK/C
NT
OK
CLEAR
P/STI
LL
LP
FF
PLAY
STOP
TV/VTR AV CM SKIP
ez POWER OFF
G-CODE C.LOCK
ez REPEAT
EJECT POWER
REC/ITR
REW