-5-
INSTALLATIONS
INSTALLING
1. Empty the microwave oven and clean inside it with a
soft, damp cloth. Check for damage such as misaligned
door, damage around the door or dents inside the cavity
or on the exterior.
2. Put the oven on a counter, table, or shelf that is strong
enough to hold the oven and the food and utensils you
put in it. (The control panel side of the oven is the heavy
side. Use care when handling.)
3. Do not block the vent and the air intake openings.
Blocking vent or air intake openings can cause damage
to the oven and poor cooking results. Make sure the
microwave oven legs are in place to ensure proper air
flow.
4. The oven should not be installed in any area where heat
and steam are generated, because they may damage
the electronic or mechanical parts of the unit.
Do not install the oven next to a conventional surface
unit or above a conventional wall oven.
5. Use microwave oven in an ambient temperature less
than 104°F(40°C).
6. Place the microwave oven on a sturdy and flat surface
at least 10 cm(4 inches) from the wall.
7. Place the microwave oven as far away as possible from
TV, RADIO, COMPUTER, etc., to prevent interference.
GROUNDING INSTRUCTIONS
For personal safety, this appliance must be fully grounded
at all times.
In the event of an electrical short circuit, grounding reduces
the risk of electrical shock.
The plug must be plugged into an outlet that is properly
installed and grounded.
BEFORE YOU BEGIN, READ THE FOLLOWING INSTRUCTIONS COMPLETELY AND CAREFULLY.
10cm
WARNING
Improper use of the grounding plug can result in a risk
of electric shock.
Do not, under any circumstances, cut or remove the
third ground prong from the power cord plug.
PREFERRED METHOD
ENSURE PROPER GROUND
EXISTS BEFORE USE
TEMPORARY METHOD
(ADAPTER PLUGS NOT
PERMITTED IN CANADA)
ALIGN LARGE
PRONGS/SLOTS
ENSURE PROPER GROUND
AND FIRM CONNECTION
BEFORE USE
Summary of Contents for LTRM1240SB
