16
• Replace cover from left side of refrigerator top onto
the right of top to cover the holes. Cover is also force-
fitted (Figure 27).
After changing doors, make sure that the corners of the
Door Gaskets are not folded over. To ensure a good seal,
apply a small amount of silicon grease on the corners of
gaskets.
Corners
CLOSING AND ALIGNING THE DOORS
To avoid vibration, the unit must be leveled. If necessary,
adjust the Leveling Legs to compensate for unevenness
of the floor. The front should be slightly higher than the
rear to aid in door closing.
Your refrigerator has two front leveling screws, one on
the right and one on the left. If your refrigerator seems
unstable or if you would like the doors to close more
easily, simply adjust the inclination of the refrigerator by
following the instructions below:
1.
Plug the refrigerator into a 3 prong grounded outlet.
Move the refrigerator into its final position.
2.
Remove the base grille (Refer to the section on
“Installation of Base Grille”
).
3.
Use a flat head screwdriver to adjust the leveling
screws (see Figure A), turning clockwise to raise the
side of the refrigerator and counter-clockwise to lower
it. It may take several turns to adjust it to the inclination
you would like.
NOTE:
Having someone push against the top of the
refrigerator takes some weight off the leveling screws.
This will make it easier to adjust the screws.
4.
Open both doors again and check to make sure that
they close easily. If not, tilt the refrigerator slightly
more to the rear by turning both Leveling Screws
clockwise. It may take several more turns, and you
should turn both Leveling Screws the
same amount.
5.
Replace the base grille.
Figure A
Door Alignment
If the space between your doors is uneven, follow the
instructions below to align the doors:
1.
Gently pry off the Top Hinge Cover with a flat head
screwdriver and remove.
2.
Loosen the Top Hinge Bolts using a 10 mm or 13/32
inch socket wrench or open-end wrench.
3.
Have someone hold the freezer door so the space
between the two doors is even, and retighten the top
hinge bolts.
4.
Replace the Top Hinge Cover.
REFRIGERATOR INSTALLATION
USING YOUR REFRIGERATOR
Fig. 27
Cover (on top of
refrigerator)
