5
EN
G
LI
SH
3
How to install the wall mount
→
If the screw cannot be assembled in the designated
location inevitably, it can be assembled by rearranging
to the closest location. But, do not change 2 or more
locations from the designated spot.
→
Assemble the wall mount screw on 2 left and 2 right
location on the top part and 1 left and 1 right location
on the bottom part.
→
At this time, use a "+" driver (Manual or motorized) or
8 mm wrench to tighten the screw so that the wall, wall
bracket and screw are completely pressed against one
another.
1. Set the display with the guide spacer assembled on the wall mount bracket on the wall in arrow direction. At this time, align the
bottom assembly part and lift the set up lightly to align the top part. (When installing a Cinema Screen set to the wall mount,
please refer to the installation section of the TV owner's manual.)
2. When adjusting the location, assemble the provide safety clip as shown in the picture to prevent the product from moving.
Tighten the safety clip screw completely. If the safety clip is not tightened as shown in the picture, the product can fall off.
→
Pull on the bottom of the set to make sure the display is secure.
→
When installing a display rotated, only rotate the display 90 degrees (portrait mode). (Only applies for VESA 200X200,
400x400)
→
The clearance from the wall is 24 mm ~ 35 mm for this product. Make sure to keep a certain level of distance from the wall so
that excessive force is not applied on the cable or accessory.
→
When you push the product with excessive force, the product can be damaged.
4
How to assemble the wall mount support and display
- Always install the display with 2 or more people.
Wall mount
screw
Safety clip
Safety clip screw
* Assemble the wall
mount support, product
and safety clip.
* Caution : Prevent the
power cord from being
pinched between the wall
mounting bracket and the
set when installing the set.
(A pinched power cord
may cause an electrical
short)
