24
WATER FILTER
Before removing or installing water filter:
1.
IMPORTANT:
Turn off household water supply.
2.
Take out the top shelf and move it to the lowest level.
Removing the water filter:
1.
For filter replacement, remove old filter by turning it
counterclockwise and pulling it down.
NOTE : The substitute cap must be retained for the
future. If the filter is removed and not replaced, it is
necessary to reinstall the substitute cap to prevent
water leaks from the filter housing.
Installing the water filter
1.
Remove the red cap from the filter.
2.
Hold the filter with the unlock symbol
facing
towards you as shown in the picture below. Insert the
filter into the filter receptacle on the right side of the
refrigerator compartment.
3.
Push the water filter up into the filter receptacle and
rotate it clockwise to lock it into place. Once installed
correctly, the lock symbol should be facing you and
you should not be able to rotate the filter clockwise
any more.
NOTE:
After installation, if you notice that the lock
symbol is not facing you or you can continue
to rotate the filter clockwise; remove the filter and
repeat installation to prevent water leaks.
After installing water filter:
1.
Replace the shelf to the initial position.
2.
After installing filter, turn on household water supply.
3.
Dispense 2.5 gallons (9,46 liters) of water to purge
the system, depressing and releasing the dispenser
pad in cycles of 30 seconds ON and 60 seconds
OFF. Open the refrigerator door and check the shelf
area for water leaks.
To purchase or replace water filters, call your Service
Center. Refer to the Warranty Card to obtain the
telephone number of the Service Center near you and
ask for part no. 5231JA2002A or ADQ72910901.
FILTER
