10
INSTALLATION
Door reversal must be done by an authorized
installer or service person. If it is not, any damage
caused by improperly installed doors will not be
covered by the warranty.
Leveling the Freezer
If the appliance seems unsteady, or the doors do
not close easily, adjust the appliance’s tilt using the
instructions below.
1
Turn the leveling leg clockwise to raise that
side of the appliance or counterclockwise to
lower it.
2
Open the door and check to make sure that
the door closes easily.
Door Alignment
The appliance door has an adjustable nut, located
on the bottom hinge, to raise and lower the door
for proper alignment.
1
Open the door and use the wrench
a
to
loosen the keeper nut by turning it to the left.
2
Use the wrench
b
to adjust the height by
turning the adjustment hinge pin to the left or
to the right.
CAUTION
• Do not adjust the height of the appliance door
more than 1/8" (3 mm).
3
Use the wrench
a
to fasten the keeper nut by
turning it to the right.
NOTE
• Leveling the doors may not be possible when the
floor is not leveled, or is of weak or poor
construction.
• The appliance is heavy and should be installed
on a rigid and solid surface.
• Some timber flooring may cause levelling
difficulties if it flexes excessively.
Turning on the Power
After installing, plug the appliance’s power cord
into a 3-prong grounded outlet and push the
appliance into the final position.
CAUTION
• Connect to a rated power outlet.
• Have a certified electrician check the wall outlet
and wiring for proper grounding.
• Do not damage or cut off the ground terminal of
the power plug.
Position the Appliance
• Arrange the coil of tubing so that it does not
vibrate against the back of the appliance or
against the wall. Push the appliance back to the
wall.
