58
Symptom
Cannot play a disc
recorded using this
recorder on another
player.
Cannot record or did
not record successfully.
Timer recording is not
possible.
Stereo Audio Record
and/or Playback is not
present.
The remote control
does not work properly.
Cause
!
The disc was recorded in Video mode.
!
Some players will not play even a
finalized disc recorded in Video mode.
!
The disc was recorded in VR mode,
!
Discs recorded with copy-once material
cannot be played on other players.
!
The remaining blank space on the
disc is insufficient.
!
The source you are trying to record is
copy protected.
!
When setting the recording channel, the
channel is tuned on the TV’s own tuner.
!
When recording to a Video mode disc,
programs that are copy-once
protected cannot be recorded.
!
Clock in recorder is not set to correct
time.
!
Timer has been programmed
incorrectly.
!
Timer record indicator light does not
appear after programming timer.
!
TV is not Stereo-compatible.
!
Broadcast program is not in stereo
format.
!
The recorder A/V Out jacks are not
connected to TV A/V In jacks.
!
The recorder Audio/Video Out is not
selected for viewing at the TV.
!
The recorder’s TV audio channel is
set to mono.
!
The remote control is not pointed at
the remote sensor of the recorder.
!
The remote control is too far from the
recorder.
!
There is an obstacle in the path of the
remote control and the recorder.
!
The batteries in the remote control
are exhausted.
Solution
!
Finalize the disc. (page 23)
!
No solution.
!
The other player must be RW
compatible in order to play it.
!
No solution.
!
Use another disc.
!
You cannot record the source.
!
Select the channel on the recorder’s
built-in TV tuner.
!
Use a VR mode formatted disc for
copy-once material.
!
Set clock to correct time. See “Auto
Clock Set” or “Manual Clock Set” on
page 18.
!
Reprogram Timer. See “Timer
Recording” on page 39.
!
Reprogram Timer.
!
No solution.
!
No solution.
!
Make A/V connections. Stereo is
available only via A/V output from the
recorder.
!
Select AUX or A/V source as TV
input.
!
Set TV audio channel mode to Stereo.
See “Changing TV audio channel” on
page 38.
!
Point the remote control at the remote
sensor of the recorder.
!
Operate the remote control within
7 m.
!
Remove the obstacle.
!
Replace the batteries with new ones.
Resetting the recorder
If you observe any of the following symptoms...
!
The unit is plugged in, but the power will not turn
on or off.
!
The front panel display is not working.
!
The recorder is not operating normally.
...you can reset the recorder as follows:
!
Press and hold the POWER button for at least five
seconds. This will force the unit to power off then
turn the unit back on.
!
Unplug the power cord, wait at least five seconds,
and then plug it in again.