3-13
COMPONENT ACCESS
Most cleaning can be done with the
drawer in place;
however, the drawer may be removed if further
cleaning is needed. Use warm water to thoroughly
clean.
1. Fully open the drawer.
2. Locate the glide lever on each side of the drawer.
Push down on the left glide lever and pull up on the
right glide lever.
3. Pull the storage drawer away from the range.
Replacing the Drawer
Pull the bearing glides to the front of the chassis glide.
Align the glide on each side of the drawer with the
glide slots on the range.
Push the drawer into the range until levers “click ”
(approximately 2 inch).
Pull the drawer open again to seat bearing glides into
position.
REMOVIING & REPLACING THE DRAWER
CAUTION
• Disconnect the electrical power to
the range at the main fuse or circuit
breaker panel. Failure to do so can
result in severe personal injury,
death, or electric shock.
CAUTION
• DO NOT touch interior surfaces of
oven between door and drawer.
- During and after use, do not touch interior
surfaces of oven between door and drawer
until they have had sufficient time to cool.
- Failure to follow this warning result in severe
personal injury.
Remove screws
Pull up with finger
Push down with finger
Lever
Lever
Pull the drawer
Lift the front
Remove screws
Pull up with finger
Push down with finger
Lever
Lever
Pull the drawer
Lift the front
Remove screws
Pull up with finger
Push down with finger
Lever
Lever
Pull the drawer
Lift the front
