41
MAINTENANCE
ENGLISH
2
Remove the filter from the inside of the cover
by pressing the side of the filter in and pulling
the center out.
3
Place the new filter inside of the cover with
the side that says
FRONT
facing outward.
4
Align tabs
a
on the filter cover with hooks
b
on the refrigerator wall.
5
Rotate the air filter cover clockwise until the
hooks engage and the cover locks in place.
6
Press and hold the
Air Filter
button on the
control panel for 3 seconds to reset the filter
sensor.
Water Filter
Before Replacing the Water Filter
WARNING
• To reduce the risk associated with choking, do
not allow children under 3 years of age to have
access to small parts during the installation of
this product.
• To reduce the risk associated with the ingestion
of contaminants, do not use with water that is
microbiologically unsafe or of unknown quality
without adequate disinfection before or after the
system. Systems certified for cyst reduction may
be used on disinfected water that may contain
filterable cysts.
• Use of unauthorized water filters may result in
product malfunction, water leakage or water
quality issues, which will not be covered under
the product warranty.
CAUTION
• Read and follow Use Instructions before
installation and use of this system.
• Installation and use MUST comply with all state
and local plumbing codes.
• Do not install if water pressure exceeds 120 psi
(827 kPa). If your water pressure exceeds 80 psi,
you must install a pressure limiting valve.
Contact a plumber if uncertain how to check
your water pressure.
• Do not install where water hammer conditions
may occur. If water hammer conditions exist you
must install a water hammer arrester. Contact a
plumbing professional if you are uncertain how
to check for this condition.
• Do not install on hot water supply lines. The
maximum operating water temperature of this
filter system is 100 °F (37.8 °C).
• Protect filter from freezing. Drain filter when
temperatures drop below 40 °F (4.4 °C).
• The disposable filter cartridge MUST be replaced
every 6 months, at the rated capacity or if a
noticeable reduction in flow rate occurs.
• To protect it from freezing, remove filter
cartridge when temperatures are expected to
drop below 33° F.
• Do not install systems in areas where ambient
temperatures may go above 110° F (43.3° C).
• Where a backflow prevention device is installed
on a water system, a device for controlling
pressure due to thermal expansion must be
installed.
