3-7 MULTI DUCT
1. Remove the upper and
lower Caps by using a flat
screwdriver, and remove
2 screws. (Figure 16)
2. Disconnect the lead wire
on the bottom position.
3-8 MAIN PWB
1) Loosen the 3 screws on the PWB cover.
2) Remove the PWB cover
3) Disconnect wire harness and replace the main PWB in
the reverse order of removal.
3-9 DISPENSER
w
w
CAUTION: When replacing the dispensor cover in the
reverse order of removal, be careful that the lead wire
does not come out and the water tube is not pinched by
the dispensor,
3-10 DISPLAY PCB
As shown below, remove 1 case PCB fixing screw.
Remove the display PCB fixing screw.
3-11 ICE BUTTON ASSEMBLY
1) Remove the screw fixing the button lever.
2) Push the spring from the hanging hook to remove it.
3) Apply some pressure to the rib in
direction and lift the
button in
direction.
3-12 FUNNEL REPLACEMENT
Pull down and forward.
Figure 16
Case, PCB
Display PCB
Button Lever
- 9 -
1) Pull out the darin
2) Hold the inner side
of cover dispenser
with both hands at the
handle side to pull it
out forward.
3) If nozzle is interfered with button , push and
pull out the bottom of button.
4) Rmove the
connected part of
Lead wire.
www.Appliantology.org
