The fire rating of this module is valid only when
mounted in the manner specified in the mechanical
mounting instructions.
The module is considered to be in compliance with
CSA/UL61730 only when the module in mounted in the
manner specified by the mounting instructions below.
The solar module may be mounted by using the
following methods: (*T
orque:8~12N∙m)
LG modules (Fire performance : Type 1 or 2) shall be
mounted with racking and mounting products certified
and listed for system fire class rating in accordance
with CSA/UL61730.
It is recommended to check with local authorities
for fire safety guidelines and requirements for any
building or structure on to which the panels will be
installed.
When installing modules in heavy snow areas,
it is recommended to be taken an appropriate
countermeasure to prevent possible damages to the
lower side frame by slipping snow.
We recommend to use corrosion resistant material
according to standard CSA/UL61730 for these
supporting part. (A snow guard should be installed in
accordance
with the manufacturer’s instructions.)
Solar module
Supporting part
Roof
Mounting by using frame bolts holes
Secure the solar module to the structure by using the
factory mounting holes.
Four M8 stainless steel bolts, four nuts, four spring
washers, and eight flat washers are recommended
per solar module.
The module may be fastened to a support by using
both the outer and inner bolt holes of the frame.
Each module should be securely fastened at a
minimum 4 points on two opposite sides.
09
→
We recommend more than 40x40mm mounting rails.
Module frame
Nut
Spring washer Flat
washer
Mounting Rail Flat
washer
Bolt
* Mounting Rails Material : Aluminum, Stainless steel, etc.
Specific information on the solar module dimensions
and location of mounting holes is provided in
‘Product
Specifications’.
Tighten the bolt securely by using the combination. Place
the spring washer between the Flat washer and Nut.
