Dehumidifier
Operating Instructions
12
Water level
control switch
The dehumidifier will turn off automatically when the bucket is full,
or when the bucket is removed or not replaced in the proper
position.
The bucket must be replaced in the proper position for the
dehumidifier to work. The light will be on and the
dehumidifier will not run if the bucket is not in the proper
position.
1
. Empty the bucket manually.
Automatic shut off
Disposing of collected water
When the bucket is full, pull out by
grasping the handle and empty it
into a large sink or tub and then
replace it properly.
Do not remove while
operating the dehumidifier.
It can cause water to drop on the
base pan or the floor.
Empty the bucket when the indicator
light turns on.
It is advisable to carry the
bucket by supporting it from the
bottom as well as by the handle.
Carrying by only the handle may
cause the handle or bucket cover to
break.
NOTICE
Bucke
t Ful
l
2 hr.
on/o
ff
4 hr.
on/o
ff
High
Low
NOTICE
NOTICE
2
.Carry water out of the drain with garden hose.
Fig1
Fig2
HOSE
CONNECTOR COVER
1. Remove the hose connector
cover and cap from hose
connector of rear grille outside.
(Fig2)
2. Carry the bucket by supporting
it from the bottom as well as by the
handle.
(Fig3)
3. Install the hose connector
cap and cover on the drain
pan.
(Fig4)
4. Connect a garden hose to
the rear grille.The connection
should be resemble Fig5 when complete.
The hose attachment will
accept a standard garden hose
fitting.
Do not over tighten the hose when
connecting it to the hose connector,use a rubber
washer and tighten by hand firmly without stripping the
plastic threads.
NOTICE
When being attached to hose connector drain hose connection, do not bend or kink the hose.
The hose should lie flat from the dehumidifier to the drain.
HOSE
CONNECTOR CAP
HOSE
Fig4
Fig3
Fig5