- 27 -
3.5.7 UMTS Rx RF filter (FL1001 : EFCH2140TDE1)
An RF filter is located between the UMTS LNA and mixer. Insertion loss is important, but not as critical
as losses before the LNA. The most important parameters of this component include:
■
Out-of-band rejection or attenuation levels, usually specified to meet these conditions:
■
Far out-of-band signals - ranging from DC up to the first band of particular concern and from the last
band of particular concern to beyond three times the highest passband frequency.
■
Tx-band leakage - the transmitter channel power, although attenuated by the duplexer, still presents
a cross-modulation threat in combination with Rx-band jammers. The RF filter must provide rejection
of this Tx-band leakage.
■
Other frequencies of particular concern . bands known to include other wireless transmitters that
may deliver significant power levels to the receiver input.
LGE Internal Use Only
Copyright © 2008 LG Electronics. Inc. All right reserved.
Only for training and service purposes
Parameter Frequency Our Prellminary spec. Unit
D/N: T2140F3A
Min. Typ. Max.
Passband
2110...2170
MHz
Insertion Ioss
2110...2170MHz
1.5
2.0
dB
Ripple in passband
2110...2170MHz
0.5
1.2
dB
Amplitude imbalance
2110...2170MHz
-1.5
-1.11
+1.5
dB
+0.73
Phase imbalance
2110...2170MHz
-10.0
-1.92
+10.0
deg.
+1.02
Attenuation
Att1
0.1...1980MHz
40
43
dB
Att2
1980...2040MHz
30
34
dB
Att3
2250...3000MHz
18
25
dB
Att4
3000...6000MHz
25
40
dB
VSWR
Input
2110...2170MHz
1.5
2.0
Output
2110...2170MHz
1.5
2.0
Input impedance (Single Ended)
50
Ohm
Output impedance (Differential)
100//10nH
Ohm
Maximum drive level
1920...1980MHz
+10
mW
DC Input level
+3
V
Operating temperature
-25
+85
deg. C
Storage temperature
-30
+85
deg. C
[Table 3.3] UMTS Rx SAW Filter Specification
Z3X-BOX.COM
Summary of Contents for KF310
Page 174: ...Note Z 3 X B O X C O M ...