7.4 Positioning of the hob
The following operation requires building and/or carpentry work so must
be carried out by a competent tradesman. Installation can be carried out
on various materials such as masonry, metal, solid wood or plastic
laminated wood as long as they are heat resistant (T 90°C).
Create an opening with the dimensions shown in the figure in the top
surface of the counter, keeping a minimum distance of
50 mm
from the
rear edge. This appliance can be mounted against walls higher than the
work surface on condition that a distance of 110 mm be kept between
the appliance and the wall as shown in the figure so as to avoid damage
from overheating. Make sure there is a minimum of
750 mm
between
the hob and any shelf that may be installed directly above it.
The dimensions indicated in the
figure are the same for all models
without
a frame.
The dimensions indicated in the
figure are the same for all models
with
a frame.
Below is supplied the table of
comparison between the dimension
Y
to be created in the worktop and
the dimension
X
of the cooker hob.
DIMENSION X DIMENSION Y
300 270
600 565
700 565
900 878
Below is supplied the table of
comparison between the dimension
K
to be created in the worktop and
the dimension
Z
of the cooker hob.
DIMENSION Z DIMENSION K
600
560
900
879
21
Ofrecido por www.electromanuales.com
