10
INSTALLATION
How to Install the Unit
Preparation of the Cabinet
1
Remove 5 screws which fasten the cabinet
at both sides and at the back. (Keep the
screws for later use.)
1
Measure the space for installation to assure
a good fit. The air conditioner must be
2
Avoid exposure to direct sunlight.
installed firmly into place to prevent vibration
and noise.
1
Remove the rubber cap from the hole under
the base-pan.
cabinet with 2-4 screws.
2
Install the drain pan over the corner of the
on the bottom of the drain pan. (You can
3
Connect the drain hose to the outlet located
satisfy your particular needs. Drain hose is not
supplied)
purchase the drain hose or tubing locally to
There must be at least 50cm (20in.) of cleared
space around the rear of the unit. Obstacles
restricting the airflow may reduce the cooling
efficiency of the unit.
3
Remove all obstacles from the rear of the unit.
towards the outside to allow condensed
water to drain. (About 10~15mm or 1/4
bubble with Level)
4
The unit should be installed with a slight tilt
Shipping
Fence
Awning
Heat
radiation
Cooled air
Screws
2
Slide the unit from the cabinet by gripping
the base pan handle and pulling forward
while bracing the cabinet.
CAUTION
●
The unit is heavy. To prevent injury, use
proper lifting techniques when pulling unit
forward from cabinet. Obtain assistance
from another person if possible.
CAUTION
●
The external grille must be exposed outside
for air discharge.
10~15 mm
Over 50 cm
Foam
70-150 cm
Level
1/4 Bubble
Drainage (Optional)
To drain the excess water, remove the drain cap
The base-pan may overflow due to high humidity.
from the base pan of the unit and secure the Drain
Pan.
Cabinet
Drain Hose
Screw
Drain Pan
Summary of Contents for JW-Q18WUXA1
Page 24: ......
