LG JW-Q18WUXA, Owner'S Manual

Page: 11 / 20

11 INSTALLATION
Installation of the Cabinet Space for Outside Air Flow
NOTE
bottom of the cabinet is well supported,
the top has minimum clearace and the
air inlet louveres have clearance as
shown. Holes from the outside through
to the cavity should be sealed. The
cabinet should slope down towards
the rear by about 10~15 mm to allow
water formed during operation to drain.
1
Prepare the hole in the wall so that the
secure. Ensure the foam seals are not
damaged. Flash, seal or fill gaps around
the inside and outside to provide
satisfactory appearance and protection
against the weather, insects and rodents.
2
Install the cabinet into the wall and
● Unit may be supported by a solid frame from
below or by a hanger from a solid overhead
support.
FLASH OR SEAL AROUND EXTERNAL
WALL FRAME OR ARCHITRAVE
STURDY TIMBER
FRAME ALL ROUND
UNIT
DRAIN CHUTE
EXTERNAL SUPPORT
FRAME AT BALANCE
POINT OF RAC
Preferred method of installation into
a timber framed wall, partition or window.
ALTERNATIVELY, BRACKETS
AS ILLUSTRATED BELOW
MAY BE USED.
TIMBER FRAMED
WALL OR PARTITION
100 mm minimum
AIR IN
AIR IN
AIR OUT
OPTION A
100mm
100mm
LOUVRE
FRONT
45 ° BRICK CUT AWAY
TO CLEAR LOUVRES
45 ° BRICK CUT AWAY
TO CLEAR LOUVRES
BRICK
WALL
AIR IN AIR IN
BRICK
WALL
AIR OUT
TOP
VIEW
OPTION B