23
INSTALLATION
ENGLISH
Leveling and Door
Alignment
Turning on the Power
The refrigerator has two front leveling legs. Adjust
the legs to alter the tilt from front-to-back or side-to
side. If the refrigerator seems unsteady, or the
doors do not close easily, adjust the refrigerator’s
tilt using the instructions below:
If the space between the doors is uneven, follow
the instructions below to align the doors:
• After installing, plug the refrigerator’s power
cord into a 3-prong grounded outlet and push
the refrigerator into the final position.
Turn the leveling leg to the left to raise that
side of the refrigerator or to the right to lower
it. It may take several turns of the leveling leg
to adjust the tilt of the refrigerator.
Open both doors and check to make sure that
they close easily. If the doors do not close
easily, tilt the refrigerator slightly more to the
rear by turning both leveling legs to the left. It
may take several more turns, and be sure to
turn both leveling legs the same amount.
1
2
• A flare nut wrench works best, but an open-end
wrench will suffice. Do not over-tighten.
NOTE
CAUTION
• Connect to a rated power outlet.
• Have a certified electrician check the wall outlet
and wiring for proper grounding.
• Do not damage or cut off the ground terminal of
the power plug.
Position the Refrigerator
Start the Icemaker
*in some models
• Arrange the coil of tubing so that it does not
vibrate against the back of the refrigerator or
against the wall. Push the refrigerator back to
the wall.
• If the water line is connected, set the icemaker
power switch to the ON position.
• The icemaker will not begin to operate until it
reaches its operating temperature of 10 °F (–12
°C) or below. It will then begin operation
automatically if the icemaker power switch is in
the ON (I) position.
Leveling
Door Alignment
With one hand, lift up both the inner and
outer door sections of the right door to raise
them at the middle hinge. (It may be easier to
lift it with the doors open.)
With the other hand, use pliers to insert the
snap ring on the middle hinge of the inner
door section as shown. Do not insert the ring
on the hinge of the outer door section.
Insert additional snap rings until the right
door is aligned. (Two snap rings are provided
with the unit.)
1
2
3