19
INSTALLATION
ENGLISH
Install the grounding screw and connect the
two wire harnesses . Push the water tube ,
located at the top of the left door into the hole
beside the left hinge on the top of
the cabinet until it exits through the back.
Hold the water supply connection and gently
push in the collet to connect the water
supply line as shown. Insert the tube at least
5/8 inch (15 mm) into the connector. Insert
the clip on the joint to fasten the tube in place.
Place the cover in place. Insert and tighten
the cover screw .
3
4
4
NOTE
NOTE
Collet Tube Insert line Clip
• Disassembling/Assembling the Water Lines
• Gently press the collet and insert the tube until
only one line shows on the tube.
Connecting the Water Line
Before Beginning
This water line installation is not covered by the
refrigerator warranty. Follow these instructions
carefully to minimize the risk of expensive water
damage.
If necessary, call a qualified plumber to correct
water hammer before installing the water supply
line to the refrigerator. Water banging in the
pipes, or water hammer in residential plumbing
can cause damage to refrigerator parts and lead to
water leakage or flooding.
• Turn the icemaker OFF if the refrigerator will be
used before the water line is connected.
• Do not install the icemaker tubing in areas
where the ambient temperatures fall below
freezing.
WARNING
• Connect to potable water supply only.
CAUTION
• To prevent burns and product damage, only
connect the refrigerator water line to a cold
water supply.
• Wear eye protection during installation to
prevent injury.
