DirectCD
TM
v2.5b(s)
5
Front Panel
Rear Panel
Location and Function of Controls
READ
READ
WRITE
WRITE
5
6
1
2
4
3
1. Headphone jack
2. Volume control
3. Emergency Eject Hole
4. Stop/Eject button
5. Disc tray
6. Drive activity indicators
Two colored LEDs are used to indicate
the operation of CD-R/RW Drive.
(1) Read
The orange color is displayed when the
spindle motor begins the Spin up oper-
ation: accessing data, reading data,
playing Audio, and up loading tray.
(2) Write
The green color is flashed during disc
writing sessions.
DIGITAL
AUDIO
ANALOG
AUDIO
INTERFACE
POWER
D G
39
40
1
+5
GND
+12
2
C S M
S L A
R G L
1 2 3 4 5
1.
Digital Audio Output Connector
2.
Analog Audio Output Connector
3.
Jumper Connector
This jumper determines whether the drive is configured as a master or slave.
Changing the master-slave configuration takes effect after power-on reset.
4.
IDE Interface Connector
Connect to the IDE (Integrated Device Electronics) Interface using a 40-pin
flat IDE cable.
NOTE : Do not connect or disconnect the cable when the power is on, as this
could cause a short circuit and damage the system. Always turn the power
OFF when connecting or disconnecting the cable.
5.
Power Connector
