iS7 Encoder Setup
1
LSIS iS7 Encoder Setup
Rev A_10-31-2018
Purpose
This document serves as a supplement to the complete iS7 User Manual. It shows how to install and setup the iS7 VFD to
utilize an encoder option board (P/N: 64110002). This option card supports line driver and open collector type encoders.
Card Installation
1. Remove the front cover of the iS7 to expose the option slot highlighted below.
2. The encoder option card is installed by lining the card up with the option connector and sliding to the right. Ensure
that the pins are lined up properly; the card should slide in easily and fit flush with the plastic cover.
3. Tighten the included screw to hold the card in place.
Slide into place
