14
EN
Adjusting the Height of the
Door
If the door of the appliance is not level, adjust the
difference in the height of appliance door using the
following method.
NOTE
•
Because the hinge pin may fall out, do not
adjust the height of the appliance door more
than 5 mm.
*Reference
Keeper nut
Keeper nut
Adjustment hinge pin
Adjustment hinge pin
1
Turn the keeper nut clockwise using the
spanner.
To loosen the nut
To loosen the nut
2
Adjust the difference in the height of the
appliance door by rotating the adjustment
hinge pin clockwise or counterclockwise with
an 8 mm spanner.
Down
Down
Up
Up
3
Fasten the keeper nut by turning it
counterclockwise.
To tighten the nut
To tighten the nut
Connecting the Water Line
(For Plumbed models
Only)
Water Supply Requirements
A cold water supply with water pressure
between 138 kPa and 827 kPa (1.4-8.4 kgf/
cm²) is required to operate the water dispenser.
If the refrigerator is installed in an area with low
water pressure (below 138 kPa), you can install
a booster pump to compensate for the low
pressure.
If a reverse osmosis water filtration system is
connected to your cold water supply, the water
pressure to the reverse osmosis system needs
to be a minimum of 138 kPa to 827 kPa (1.4-8.4
kgf/cm²)
WARNING
•
Unplug the appliance before carrying out any
work on connecting the water line. Failure to do
so may cause electric shock.
•
Only connect the water line to a cold water
supply. Failure to do so may cause the water
filter to malfunction. Water hammer (water
banging in the pipes) in house plumbing can
cause damage to appliance parts and can lead
to water leakage or flooding.
•
Connecting the water line must only be installed
by a qualified plumber and in accordance with
local legislation and regulations governing water
quality.
Summary of Contents for GC-X247CSBV
Page 45: ...Memo ...
Page 46: ......