LG G5200, Service Manual

Page: 123 / 135

12. Auto Calibration
- 122 -
• Connection
➞
Connect to phone : Connect to the phone which you want to measure. This
procedure checks whether the PC is connected to
“Ag8960” or not. If not connected to “Ag8960” try to
connect to “Ag8960”. After that it performs sync. procedure
with phone. If the sync. procedure is successful state
column on statusbar changed to SETUP else you should
disconnect phone and try it again from the beginning. All
measurement is performed at state SETUP
• Connection
➞
Disconnect phone : Disconnect phone.
• Connection
➞
Port setting : Show COM port setting dialog you can change port
number, baud rate etc.
• Connection
➞
Connect to Ag8960 : Connect to Agilent 8960.
• Connection
➞
Disconnect Ag8960 :Disconnect Agilent 8960.
• Option
➞
Settings
➞
Gpib state : Show current primary Gpib state.
• Option
➞
Settings
➞
MPL : Set max Tx power level used in APC procedure.
• Option
➞
Settings
➞
CL : Set cable loss value.
• Option-
➞
Settings
➞
Bin file : Set default binary file name.
Figure 12-2. Buttons and status bar
1. Connect to phone
2. Disconnect phone
3. Port setting
4. Connect to Ag8960
5. Disconnect Ag8960
6. AGC tab
7. APC tab 8. Result window
9 . Band setting
10 . Sync. Button
(button 2 + button 1)
11. Start measure
12. Save result
13. Clear result window
14. Port connection state
15. Retry button
16. Ag8960 connection
state
17. Informations.
18. Current state.