34
MAINTENANCE
Removing and inserting the hook-in
racks
You can remove the hook-in racks in order to clean
them separately.
The hook-in racks are all fixed to the walls of the
cooking compartment at four points.
Removing the hook-in racks
To remove the hook-in racks, proceed as follows:
1
Undo the scre w on the bottom the hook-in rack
again.
The lower hooks of the hook-in rack are released.
2
Take hold of the top of the hook-in rack and screw
on the screw on the bottom the hook-in rack again.
Inserting the hook-in rack
To reinsert the hook-in racks, proceed as follows:
1
Insert the upper hooks into the drill holes in the
side panel.
2
Pull the hook-in rack slightly downwards and
insert the lower hooks into the drill holes.
Replacing the oven light bulb
If the oven light bulb fails, it must be replaced.
Replacement heat-resistant bulbs can be obtained
from the after-sales service or from specialist retailers.
Please specify the SN number of your appliance.
Do not use any other type of bulb.
WARNING
•
MAKE SURE THE OVEN AND
THE LIGHTBULB ARE COOL.
•
UNPLUG THE COOKER FROM
THE MAIN FUSE. FAILING
TO DO THIS COULD CAUSE
SEVERE INJURIES, ELECTRIC
SHOCK OR DEATH.
Proceed as follows:
1
Switch off the relevant circuit breaker.
2
Open the appliance door.
3
Lay a tea towel in the cooking compartment if it
is cold to prevent damage.
4
Unscrew the glass cover from the bulb inside the
cooking compartment by turning it anti-clockwise.
5
Replace the bulb with one of the same type.
Voltage: 230 V~
Power: 25 W
Thread: G 9
6
Screw on the glass cover again.
7
Remove the tea towel and switch the circuit
breaker back on.
Press the function button the oven lighting until it
locks into place in order to check whether the oven
lighting is working properly.
Summary of Contents for FA415RMA
Page 121: ...40 ةركذم مذكرة ...
Page 122: ...39 ةركذم عربي مذكرة ...
