8
nstallation
I
Normal Tap without thread & screw type inlet hose
Normal Tap without thread & one touch type inlet hose
1
.
Unscrew the fixing screw to
attach the tap.
2
.
Push the connector up till the
rubber packing is in tight contact
with the tap. Then tighten the 4
screws.
3
.
Push the water supply hose
vertically upwards so that the
rubber packing within in the hose
can adhere completely to the tap
and then tighten it by screwing it
to the right.
1
.
Untighten the upper connector
screw.
2
.
Push the upper connector up till
the rubber packing is in tight
contact with the tap. Then tighten
the 4 screws.
3.
Connect the water supply hose to
the middle connector, pushing
the plate down.
• Your machine comes with only
cold water connection.
• Make sure that there are no
kinks in the hose and that it is
not crushed.
• Make sure that the rubber
seal is inside the hose
connector.
• In case the diameter of the
tap is large remove the guide
plate.
• Turn the middle connector not
to have water leaked.
• To separate the water supply
hose from the middle connector
shut off the tap. Then pull the
inlet hose down, pushing the
plate down.
Upper
Connector
Upper
Connector
Upper Connector
Upper Connector
Upper Connector
Upper Connector
Plate
Plate
Water supply hose
Water supply hose
Fixing screw
Fixing screw
Rubber
packing
Rubber
packing
Middle
connector
Middle connector
Hose
connector
Guide plate
Connector
Used the horizontal tap
Horizontal tap
Extension tap
Square tap
Rubber
seal
Rubber packing
Rubber packing
