LG DLEX8377WM - SteamDryer Series - 27in Front-Load Electric Dryer, Training Manual

Page: 15 / 86

TRAINING MANUAL DLEX8377WM
DLEX8388WM Page 13 STEAM DRYER
INSTALLATION
(Pedestal) continued
Holding the adhesive part of the bracket
away from the dryer, insert the screws and
get them started.
Press the bracket onto the dryer and
tighten the screws.
Press the brackets onto the sides of the
dryer and rub the brackets from side to
side to ensure the total adhesive area is
attached completely.
Tighten all the screws securely.
Lower each leg of the dryer one-fourth turn
with the adjusting wrench to put a little
pressure between the dryer and pedestal
to prevent any motion and rattling.
Push the dryer into place.
Check the level and adjust the front legs of
the pedestal as necessary. Then lock down
the adjusters.
The pedestal kit includes the mounting
plates (with adhesive covered by paper)
and the screws to attach the plates.
Remember, some pedestal kits come with
two sets of brackets. The flat tops are for
washers; the curved tops (shown) are for
dryers. Use the correct brackets for your
application. The curved bracket is for
clearance of the exhaust vent when a dryer
has been converted to side venting.