LG DLEX7600 SERIES, Service Manual

Page: 60 / 75

60
22. Clean the glass on the door and door cover, if necessary.
Make sure the two gray interlock buttons are properly installed and that the top
and side lock rods are properly aligned where they meet. Carefully lower the door
cover into place, aligning the holes in the cover with the interlock buttons on the top
and the bumpers on the bottom. Take care not to dislodge the lock rods while
mounting the door cover. Once the door cover is in place, secure it with the 12 screws
removed in step 9.
NOTE
Please check again if the spring is well assembled
into the outer door panel.
23. While supporting the door, install the four hinge screws removed in
step 2. Test the swing of the door to make sure the hinges and latch
are properly aligned and that the door opens, closes and latches
properly in both directions.
If the door doesn’t operate smoothly, remove the door and then the
door cover to check that the lock rods and interlock buttons are
properly mounted and aligned.
The interlock buttons should be oriented correctly and operating
smoothly. The interlock rods should be in the proper position and
should not overlap at the contact point.