LG D1453AB, Owner'S Manual

Page: 10 / 36

10
• This dishwasher may be fed with either hot or
cold water. If the water can not be maintained
below 65ºC, the dishwasher must be connected
to cold water.
• When connecting, you may use sealant tape or
sealing compound to avoid water leaks.
• Make sure that the line is not kinked or sharply
bent.
• It is recommended that the new inlet hose be
used and not the existing or old hose.
Final check and assembling
1. Securely hand tighten supply hose to the
water supply.
Plug the power supply cord into an earthed
electrical point and switch on.
2. After installing and prior to using the
dishwasher with crockery, we recommend
that you use the dishwasher on
Quick
mode
to rinse through. At this stage it is useful to
ensure that there are no operating problems or
water leaks.
When the dishwasher is used for the first
time, there may be a loud noise, if this
happens, turn off the power and restart the
dishwasher.
After installing the dishwasher, you may notice a
slight sticking of the door to the dishwasher,
when you open or close the door. If this does
happen you need to adjust the level of the
dishwasher.
• If the door slants to the right, see fig. C and
follow these instructions:
1) Unscrew(counter-clockwise) the left leg of
the back side and correct the level.
2) Check the opening of door and repeat if
necessary until the door opens and closes
properly.
• When the product is correctly leveled, there
should be no slant, stickiness or friction sound.
Fig. C
Case 1. In case the door is slanted to the right
• If the door slants to the left, see fig. D and
follow these instructions:
1) Check the opening of door if there still
remains sticky or friction sound.
2) Check the opening of door and repeat if
necessary until the door opens and closes
properly.
• When the product is correctly leveled, there
should be no slant, stickiness or friction sound.
Fig. D
Case 2. In case the door is slanted to the left
Water tap
Fig. A
Fig. B
Connect the water supply hose to the water tap.
(Fig. A)
Some models consist of an inlet valve and hose.
(Fig. B)
After connecting the inlet hose to the tap, turn on
the tap to flush out foreign substances (dirt, sand
or sawdust) in the water lines. Let water drain
into a bucket, and check the water temperature.
Connect the supply hose to the water inlet valve.
INSTALLATION INSTRUCTIONS
Installation of water inlet hose How to level the dishwasher