Function
30
1. Press
the
KEY.S
button on the remote control.
2.
Press the
∧, ∨
buttons to select a desired option and press the
＞
button.
3.
Press the
∧, ∨, ＜, ＞
buttons to adjust the screen and press
OK
.
ꔈ
The Keystone is adjusted -100 to 0 or 0 to 100 depending on position.
ꔈ
To reset to the factory defaults, perform
Picture Reset.
ꔈ
You can select this function through the
MENU
button
.
ꔈ
Press the
BACK
button to exit the menu screen
.
Using Keystone
* To prevent the screen image from becoming trapezoidal, Keystone adjusts the top and bottom width of the image if the projec-
tor is not set at a right angle to the screen.
* Because the Keystone function may cause inferior screen image quality, use this function only when it is not possible to set up
the projector at an optimal angle.
* You can adjust screen size and focus while installing the projector.
Press the
RATIO
button on the remote control
.
Press the
PATTERN
button on the remote control.
ꔈ
You can select this function through the
MENU
button.
Using the Screen Size Function
Test Pattern Function
ꔈ
Settings may vary depending on the input signal.
ꔈ
You can also use the
MENU
or
Q.MENU
button
.
ꔈ
Press the
BACK
button to exit the menu screen.
FK
ꔦ
A
Aspect Ratio
16:9
16:9
Set By Program
Just Scan
Cinema Zoom1
4:3
Zoom
Keystone
Top Right
Bottom Left
Top left
ꔃ
Bottom Right
Reset
ꔂ
Move
ꕉ
Prev
Test Pattern
* You can flip the video up/down or left/right.
1. Press
the
MENU
button, then go to Screen with the
∧, ∨, ＜, ＞
buttons and press
OK
.
2. Press the
∧, ∨
buttons to go to Projection Mode and press
OK
.
ꔈ
Select Rear to project an image onto the back of a transparent screen purchased separately
.
ꔈ
Select Ceiling if you installed the projector on a ceiling.
ꔈ
You can select this function through the
MENU
button.
ꔈ
Press the
BACK
button to exit the menu screen.
Changing Projection Mode (PJT Mode)
Press the
AUTO
button on the remote control.
ꔈ
If you use AUTO for video signal from a PC, you may not be able to get
optimized picture quality. Therefore, use the AUTO function for still images.
ꔈ
You can select this function through the
MENU
button
.
Using the AUTO Function
* AUTO provides optimized picture quality by automatically calibrating the mismatch of horizontal width and picture shake
caused by clashes between the internal settings of the projector and various PC graphic signals in RGB mode.
* The AUTO function is available only for RGB input.
Auto Config.
H 0
V 0