DirectCD
TM
v2.5b(s)
6
Rear Panel
Analog Audio Output
Connector
Jumper Connector
Power
Connector
Digital Audio
Output Connector
IDE Interface Connector
1.
Power Connector
Connects to the power supply (5-and 12-V DC) of the host computer.
NOTE : Be careful to connect with the proper polarity. Connecting the
wrong way may damage the system (and is not guaranteed). Usually this
connector can only be attached one way.
2.
IDE Interface Connector
Connect to the IDE (Integrated Device Electronics) Interface using a 40-
pin flat IDE cable.
NOTE : Do not connect or disconnect the cable when the power is on,
as this could cause a short circuit and damage the system. Always turn
the power OFF when connecting or disconnecting the cable.
3.
Jumper Connector
This jumper determines whether the drive is configured as a master or
slave. Changing the master-slave configuration takes effect after power-
on reset.
4.
Analog Audio Output Connector
Provides output to a sound card (analog signal). Generally you need this
to play a regular audio CD.
5.
Digital Audio Output Connector
Provides output to a sound card (digital Signal).