10
PRODUCT INTRODUCTION
ENGLISH
Type 1
Type 2
Forced Operation Button
Forced Operation Button
Room Temp.
≥
24 °C
21 °C
≤
Room Temp.
< 24 °C
Room Temp. < 21 °C
Operating mode
Cooling
Healthy
Dehumidification
Heating
Indoor FAN Speed
High
High
High
Setting Temperature
22 °C
23 °C
24 °C
Heat pump Model
Room Temp.
≥
24 °C
21 °C
≤
Room Temp.
< 24 °C
Room Temp. < 21 °C
Operating mode
Cooling
Healthy
Dehumidification
Heating
Indoor FAN Speed
High
High
High
Setting Temperature
22 °C
23 °C
24 °C
Test Operation
During the TEST OPERATION, the unit operates in cooling mode at high speed fan, regardless of
room temperature, and resets after 18 minutes. During test operation, if the remote controller
signal is received, the unit can be set by the remote controller. If you want to use this operation,
Press and hold the ON/OFF button for 3 ~ 5 seconds, then the buzzer sound 1 will ‘beep’. If you
want to stop the operation, re-press the button.
Operating Method
The signal receiver is inside the unit.
• Point the remote control towards the signal receiver at the right side of the air conditioner to
operate it.
−There should not be any obstacles blocking the remote controller.
Forced Operation
Forced operation is used when the remote controller can’t be used.
1
The operation will be started if the ON/OFF button is pressed.
Summary of Contents for ATNQ18GQSK1
Page 31: ...31 ENGLISH ...
Page 32: ......
