14
ENGLISH
OPERATING INSTRUCTIONS
Cooling Mode
1
Press
|
button to turn on the indoor.
2
Press
a
button to select Cooling
operation mode.
- When canceling operating, press
|
button once more.
3
Adjust the desired temperature by
pressing (
) buttons.
- If desired temperature is higher than
room temperature, cooling cannot be
conducted.
- Set the temperature lower than the room
temperature
- Setting Temp Range : 18 °C~30 °C
Egypt Only : 20 °C~30 °C
Heating Mode
1
Press
|
button to turn on the indoor.
2
Press
d
button to select Heating
operation mode.
- When canceling operation, press
|
button once more.
3
Adjust the desired temperature by
pressing (
) buttons.
- If desired temperature is lower than room
temperature, heating cannot be conducted.
- Set up desired temperature higher than
the room temperature
- Setting Temp Range : 16 °C~30 °C
Egypt Only : 16 °C~28 °C
Airflow Setting
We can simply adjust the desired airflow
direction.
Up/Down Airflow Direction Control
1
Press
|
button to turn on the indoor.
2
Press
I
button and the louvers will
swing up and down.
3
Press
I
button again to set the horizontal
louver at the desired airflow direction.
Left/Right Airflow Direction Control
1
Press
|
button to turn on the indoor.
2
Press
J
button and the louvers will
swing left and right.
3
Press
J
button again to set the vertical
louver at the desired airflow direction.
<Airflow Setting Table>
Fan Speed Setting
1
Press
|
button to turn on the indoor.
2
Press or
g
button to select fan
speed.
- You can select the fan speed in four
steps Low, Mid, High, Super High.
Each time the button is pressed, the fan
speed mode is shifted.
- Air flow rate can be selected during the
cooling, heating, dehumidification,
blowing, and auto operation mode.
NOTE
!
What is 3 minutes delay function?
The reason that cold wind is not coming out
when operating the unit after turning off the
cooling is because of the function to protect
compressor. Cold wind will be coming out
when compressor is operated after 3 minutes.
NOTE
!
Preheating operation
When conducting heating operation at the
condition of low outdoor temperature, the
case that wind is not coming out for several
minutes under the state of lighting of defrost
lamp may be occurred. This is the preheating
stage to supply warm wind which will be
supplied subsequently in short time.
Symbol
Description
I
Up
·
Down : Vane move from up to
down automatically and
continuously
J
Left
·
Right : Vane move from left to
right automatically and continuously
OPERATING INSTRUCTIONS
Heat Pump
