INSTALLATION INSTRUCTION
ENGLISH
17
3
Please fix remote controller upper part into
the backplate attached to the surface of
the wall, as the picture below, and then,
connect with backplate by pressing lower
part.
- Please make sure to leave no gaps on the
top, bottom, left or right sides between
the remote controller and backplate.
- Before assembly with the backplate,
arrange the Cable not to interfere with
circuit parts.
Remove remote controller by inserting a
screwdriver into the lower separating holes
and twisting to release the controller from
backplate.
- There are two separating holes. Please
individually separate one at a time.
- Please be careful not to damage the
inside components when separating.
4
Please refer to the following directions
when connecting the indoor unit and the
wired remote controller together.
- Please connect the cables as shown in
the figure below when connecting the
plug type cable from the indoor unit’s
C/BOX and the housing type of the
extension cable.
- When connecting Terminal Blocks of the
indoor C/BOX and the wired remote
controller with the extension cable, refer
to the steps below.
①
Remove the screw on the cable which
is fastened to the wired remote
controller’s Terminal Block by loosening
with a screw driver.
②
Remove the housing of the provided
32ft extension cable with a cutting
nipper and peel it as shown in the figure
below. (when purchasing the extension
cable at the site directly, please peel it
as shown in the figure below.)
Wall
Side
Wall
Side
<Connecting order>
Please check if the connectors
are connected properly.
C/BOX Cable (Plug type)
Extension cable(housing type)
Indoor
Unit side
TEMP
FAN
SPEED
OPER
MODE
Wall
Side
Wall
Side
<Separating order>
• Specification of LG supplied extension
cable: AWG#22, 3 core shielded.
(Model : PZCWRC1)
* Apply enclosed noncombustible
conduit(metal raceway) totally or use
FT-6 rated cable or above level in case of
local electric & building code that
requires plenum (CMP) cable usage.
1.378 inch(35 mm)
±0.197
inch(5 mm)
0.394 inch(10 mm) ± 0.118 inch(3 mm)
Signal
Yellow
12 V
Red
GND
Black
CAUTION
!
Summary of Contents for ANNQ60GKA4
Page 23: ......
